Category: SaberForge
Tri Cree LED-modulet bruger tre XPE-2 LED'er monteret på et kobber-MCPCB.
LED'erne samles internt, inkluderer modstande og er placeret inde i det viste LED-modul.
| Specifikationer | |
|---|---|
| Diameter | 0.995 in |
| Højde | 0.755 in |
| Materiale | Kobber |
The copper MCPCB on this thing actually pulls heat away nicely, I ran it for twenty minutes straight and the housing stayed warm but never hot. Resistors pre-soldered saved me a lot of fiddling.
Swapped this into a flashlight build and the three XPE-2 emitters are noticeably brighter than the single LED I had before. Came pre-wired with resistors already on the board, so I had it running in about ten minutes.
The copper base makes a huge difference for heat—even during a long duel, the hilt stays comfortable to grip. I wired it in under an hour, and those three XPE-2s throw out a seriously bright, even beam. Very happy with how clean the solder points are on the board.
